Why is my Weiser lock flashing red?
Why is my Weiser lock flashing red?
The battery is too low to lock the door. This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.
Why is my smart door lock not working?
Check for low batteries. If the red light on the back of your door lock is blinking or if you have a low battery alert on your touchscreen panel, you’ll need to replace your batteries with four new AA batteries. If the key doesn’t turn smoothly, check for physical obstructions to the lock or in the door jamb.
How do I reset my Weiser Electronic deadbolt?
Weiser Lock reset: Hold the program button for 30 seconds until the status LED flashes red. Press the program button again. The lock has been reset when the LED flashes green. Verify the lock has been reset by pressing the lock button while the door is open.
Why won’t my key unlock my deadbolt?
If the key won’t turn in the door lock, the problem could be dirt or dust in the cylinder causing the pins to be stuck in a partially raised position. If that’s the case, it may be an easy fix. You can spray dry lubricant into the keyway and then insert the key a few times to get the lubricant working.
Why is my Weiser lock flashing green?
Low battery. Replace batteries. Keypad flashes green with continuous beeping sound for two seconds.
Why is my Weiser lock flashing yellow?
Prior to the battery dying, the interior LED will flash yellow/red or green/red. In addition, the exterior keypad flashes red and the lock beeps for about 3 seconds upon code entry to notify the user far in advance to change the batteries.
Why is my keypad lock not working?
If you find that the issue is the lock, try rebooting the lock first. To reboot the lock, remove one battery from the lock and replace it. Once you have rebooted the lock, try the entry code again. If this does not work, the keypad must be reset.
How do you troubleshoot a smart lock?
As with many electronic devices, a simple reboot might fix what’s ailing a smart lock. The way to signal a reboot is to disconnect the power source and restart it. Normally, this can be done by removing a battery and reinserting it. The lock will cycle through its startup procedure and hopefully get back to work.
How do I reset my electronic lock?
A factory reset will delete all codes associated with the lock.
- Make sure the door is open and unlocked.
- Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
- Press and release the program button. You will hear one short beep.
