What is scuttle hole?

A scuttle attic is an attic space accessed by a small hole in the ceiling. The hole, along with the panel that covers it, is called a hatch. Because the term ”scuttle attic” refers to the opening rather than the attic itself, you might also see it called a ”scuttle hole” or an ”attic hatch.

How do I hatch airtight in my attic?

In exterior doors, the strike and latch hold the door pressing tightly against the weather stripping to form an airtight seal. In most typical attic hatches, there is only a thin piece of stick-on weatherstripping placed on the top edge of the drywall protruding into the attic opening.

How do you install scuttle hole?

  1. Cut scuttle hole in ceiling. If it’s not already done, cut a hole in your ceiling for the scuttle hole access point using either a hack saw or sawzaw.
  2. Frame out edge of attic access hole.
  3. Cut new drywall panel for attic access hole.
  4. Fill nail holes.
  5. Caulk edges of framing.
  6. Prime and paint.

How big should a scuttle hole be?

A scuttle hole is usually a 2′ x 2′ entrance hole to the attic, covered by a panel. Often, the panel fits badly and rarely insulated.

What is attic scuttle?

Basically, a scuttle attic is a hole in the drywall ceiling that leads to the attic with a small attic access panel that covers it. Our small little attic access panel would technically be referred to as a scuttle attic.

How do I stop the draft from my loft hatch?

If the loft hatch is hinged, you will need to put either the compression seal or the foam strip on the outside perimeter on the top of loft hatch. You will also need to put an equivalent strip on the inside of the hatch frame so that the two strips meet, creating an airtight barrier to stop the draughts.

Should attic access be sealed?

Good air-sealing and a continuous air barrier between the attic and the home’s conditioned (living) space are important, not only to save energy and reduce fuel bills, but also to prevent moisture problems in the attic.

Why is it called a scuttle hole?

A scuttle attic hole is a small attic access point in the ceiling of some buildings; a ceiling attic door. This hole is covered with a piece of material, typically drywall, called the hatch. The term “scuttle” simply means a hole. Though used as a verb, it means to make a hole in a boat to sink it.

How do you insulate an attic scuttle hole?

Attic Hatch (Scuttle Hole) Cut out two pieces of rigid foam board that are 1/4-inch smaller than the hatch, so homeowners can slide the attic access panel open easily. Attach the two layers of foam board together, and apply them to the hatch. Install fiberglass batt insulation on top of the foam board.

How do you frame a scuttle hole?

How to Frame an Attic Scuttle

  1. Cutting The Hole.
  2. Run a stud finder across the ceiling and locate the floor joists.
  3. Mark off the length and width of the attic scuttle onto the ceiling with a pencil, using the dimensions given with the attic scuttle.
  4. Cut the ceiling along the tracing with a utility knife.

How big is a scuttle attic?

For a scuttle hole installed in the ceiling of the home, the rough framed opening must be a minimum of 22” x 30”; in the case of a home where the scuttle hole is in a vertical wall, such as the wall of a garage which is open to the rafter, the scuttle hole must measure the same minimum dimensions.