Why is my Pentair salt Cell blinking?
Why is my Pentair salt Cell blinking?
If the “Inspect Cell” light flashes by itself it is an early indication that the salt generator needs a manual reset. Each cell is equipped with 500 operational hours and requires a manual reset once it expires. To reset the cell, hold down the “Diagnostic” button for 3-5 seconds.
How do I reset my IntelliChlor salt cell?
Press the “More” button to cycle through each salt level, and then press the “Less” button to choose and save the display as the new salt level. The “PWR”, “Cell”, “Life”, and “Flow” lights will flash 4 times, then the mode exits to normal.
Why is my salt cell blinking green?
The Intellichlor operates on a series of on/off cycles, this light will cycle on and off. If the Cell LED light is green, chlorine is being produced, if off, the unit is in the off mode. If the Cell light is flashing, it means there is a potential that the unit needs cleaning.
Why is the flow light red on IntelliChlor?
The “cell” light will only come on when it’s making chlorine. If the red flow light is lit, the SWCG “thinks” there is little or no water flowing through it and will no operate, no matter what. If it’s under warranty, give Pentair a call.
Why is my chlorinator flashing?
Check Cell Light Flashing: This occurs mostly in salt chlorinators over 5 years old, basically it means that the cell has reached its maximum amount of running hours and needs to be replaced.
How do I know if my IntelliChlor flow switch is bad?
If the cell light says cold when the water is warm, the temperature sensor inside the flow switch assembly is likely bad. If you are going to replace the flow switch anyway, you can just cut the green and white wires going from the flow switch assembly and the cell itself.
How do you reset a salt cell?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do I know if I need a new salt cell?
That said, here are solid indications the salt cell likely needs cleaning, repair or replacement:
- The power center displays a Check Salt message.
- The Cell Warning light displays consistently, shutting off for only a short while after cleaning.
- Voltage is higher than normal.
How do I know if my Pentair salt cell needs replacing?
What Are Some Signs That Your Salt Cell May Need Replacing?
- Looking worse for wear, it’s lost a few plates and the acid baths just aren’t working.
- Your pool is starting to turn green or cloudy, even though your chlorinator is turned up to 100%.
How do you reset the check cell on a saltwater pool?
How long should a Pentair salt cell last?
about five years
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years. Eventually, though, it will need to be replaced.
How long does a Pentair Intellichlor ic40 last?
The intellichlor Salt Cell has a lifetime of approx 10,000 hours. To check this, press and hold the more button for 3 seconds. The lights should scroll through and leave a few of the percentage lights lit up. The amount of lights corresponds to the amount of life used.
How can I check my ic40 life?
How do you reset check cell light?
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How long does a Pentair intellichlor ic40 last?
