Does a PerTronix distributor have mechanical advance?

This distributor is equipped with an advance curve that enables it to be used legally on vehicles outlined in the application guide. It is factory set at 24° of centrifugal advance and includes silver advance springs.

What is the air gap for PerTronix Ignitor?

(1) – IGNITOR II AND MAGNET SLEEVE AIR GAP CAN BE ADJUSTED ANYWHERE BETWEEN 0.010” AND 0.050”.

Who owns PerTronix ignition?

LOS ANGELES–(BUSINESS WIRE)–Charger Investment Partners (“Charger”) announced today that one of its affiliates has completed the acquisition of PerTronix, LLC (“PerTronix”).

Are PerTronix distributors Made in USA?

Our distributor are made in china and we buy them complete. Therefore, we do not have parts to sale, like the springs and stuff. I’m sorry but we wouldn’t be able to get you parts for your rebuilds. PerTronix Inc.

What type of distributor is PerTronix?

Industrial Electronic Distributors PerTronix is the leading producer of Electronic Distributors for gas, propane, and LP powered industrial engines. Many Wisconsin and Continental engines are equipped with our industrial electronic distributors from the factory.

How do I know if my PerTronix ignitor is bad?

Check sticker on the backside of module “Ignitor by PerTronix” If the Sticker is shriveled up, wrinkled, cracked, or if you see any burn marks on that side of module the unit over heated and failed for various reasons.

Are PerTronix coils good?

Tough and powerful, these coils provide consistent spark throughout your rpm range up to 11,000 engine rpm. They have an optimized coil design that delivers up to 15 percent more spark energy to your plugs than OEM coils.

What coil should I use with PerTronix Ignitor?

The 3.0-ohm coil should be used on PerTronix Ignitors installed on four- and six-cylinder engines while 1.5-ohm coils should be used for eight-cylinder applications. These coils can be used on virtually any inductive (non-capacitive discharge) ignition system.

How does PerTronix ignition work?

“The points operate mechanically with a rubbing block that rubs on a small cam in the distributor. This rubbing block wears, which changes the timing and the point gap, altering both the performance and the amount of spark available,” Don explains.

Where are PerTronix ignition made?

The exhaust products distribution and product development has now been relocated to a new 60,000 square foot facility in Irwindale, California. In December of 2008 JBA Performance Exhaust became part our growing family of exhaust brands.

Where is PerTronix distributors made?

Quote: Our distributor are made in china and we buy them complete. Therefore, we do not have parts to sale, like the springs and stuff.