How do you use CTEK battery analyzer?

Simply attach the clamps to the battery and follow the on screen step by step instructions. The Analyzer tests the battery in seconds for an instant result. The test won’t put any load on your battery and it doesn’t generate any heat or dangerous sparks.

What do the lights on a CTEK charger mean?

The power lamp will indicate that the mains cable is connected to the wall socket. The error lamp will indicate if the battery clamps are incorrectly connected. The reverse polarity protection will ensure that the battery or charger will not be damaged.

How do you use a battery analyzer?

Hand-Held Battery Load Testers

  1. Connect the hand-held load tester leads to battery (observing electrical polarities).
  2. Turn on tester, and input battery specifications (e.g. size, capacity, cold cranking amps).
  3. Press the test button to perform the test.
  4. Read the results from the tester’s screen or print-out.

How do I know if CTEK is charging?

The CTEK Indicator Clamps is really easy to attach. Simply clip the red clamp to the positive pole and the black clamp to the negative charge point or vehicle chassis. If it flashes orange, the battery is below 90% state of charge and charging is recommended.

What are the stages of a CTEK charger?

Step 1–2 (Desulphation, Soft Start): Wakes up the battery and tests to see if it can take charge.

  • 4 Step 3–4 (Bulk, Absorption):
  • 5 Step 5 (Analyze):
  • 6 Step 6 (Recond):
  • 8 Step 7–8 (Float maintenance, Pulse Maintenance):

Is it OK to leave a CTEK charger on all the time?

Can I leave the charger connected to the battery for a long time? Yes. CTEK chargers are designed to fully charge a battery and then automatically switch over to long term maintenance. Before leaving the charger unattended for a long time, ensure that the battery is fully charged, as indicated by the green LED.

How long does it take to charge CTEK?

How long will it take to charge the internal battery from totally drained to fully charged? From “Less than 10% left” – (first led blinking) to fully charged, it will take up to 60 minutes, as long as CTEK standard accessories are used.