Can you disable Bendix Wingman?

The driver can switch the Bendix® Wingman® ACB system off manually by either stepping on the brake, switching OFF the cruise control, or turning the vehicle ignition off. NOTE: Cruise control will automatically cancel whenever Bendix® Wingman® ACB applies the foundation brakes.

How do I reset my Bendix ABS module?

(The traction dash lamp will be illuminated) RESET: The ECU can be magnetically reset by momentarily holding a magnet against the RESET area on the controller.

What is Bendix Wingman Fusion?

2 Bendix® Wingman® Fusion™ integrates next-generation advanced safety technologies (radar, camera, brakes, and SafetyDirect®) into one comprehensive driver assistance system that’s more powerful than other safety system technology combinations in the North American commercial vehicle marketplace today.

What is the proper way to adjust the radar sensors lateral alignment?

During the adjustment, turn the vertical alignment screw clockwise or counterclockwise depending on the vertical direction (up or down) needed. Clockwise aligns the radar sensor up and counterclockwise moves the radar sensor down.

How do you permanently turn off collision mitigation brakes?

To turn off CMBS, simply press and hold down the CMBS button (located to the left of the steering column) until you hear an audible beep and a message appears in the Multi-Information Display. The CMBS will remain deactivated until the engine is shut down.

How do I turn my on guard off?

The OnGuardTM system can be disabled by removing the fuse through which power is provided to the system. Before removing the correct fuse, the vehicle ignition switch must be turned off and the battery disconnect switches must be shut off.

How many seconds does wingman fusion give to steer clear of a stationary vehicle?

A Stationary Vehicle Alert (SVA) may be issued up to three‑and‑a‑half (3.5) seconds prior to impact. You must immediately act to potentially avoid, or lessen the severity of, a collision.

How does the fusion system slow down a vehicle?

Overspeed Alert & Action: Fusion’s camera is capable of reading most North American roadside speed limit signs. When the camera detects that the vehicle is traveling +5 mph/8 kph over the posted speed limit, Fusion will alert your driver to slow down.

Can you disable automatic emergency braking?

Some drivers still want to be in full control of their vehicles. Others claim AEB systems brake unnecessarily. Luckily for these folks, most automakers allow you to switch your auto braking off and back on. The upcoming government mandate compels automakers to include an automatic braking system by 2025.

How do I reset CMBS?

The system can only be reset by stopping the car, turning off the ignition and then re-starting the engine. While driving 50 mph, the Collision Mitigation Braking System engaged and caused the vehicle to brake without warning.

How do I disable collision mitigation system Freightliner?

Before turning on the key press both up and down arrows on the display. While holding both arrows turn the key on. You can now release the arrow keys. Without turning off the key you can now start the mh and the collision mitigation will be off.

What happens if you disconnect ABS sensor?

Removing a wheel speed sensor will disable ABS—and sometimes, stability control. If your car has a yaw sensor, you can unplug that for results. You can also try simply unplugging the ABS module, though that could adversely affect your car’s braking performance.