How do I find the interface configuration on an HP switch?

You can use the options with the startup config command, show config, and the running config command, show running-config.

How do I configure the uplink port on my HP switch?

To enforce an uplink:

  1. Go to Configuration > System > Show advanced options.
  2. Expand Uplink.
  3. Under Management, select the type of uplink from the Enforce uplink drop-down list. If Ethernet uplink is selected, the Port text box is displayed.
  4. Specify the Ethernet. interface port number.
  5. Click Save.

What is the default ip of HP switch?

192.168.2.10
The HP ProCurve Switch 1700 Series has a default IP address of 192.168. 2.10 with a subnet mask of 255.255.

How do I reset my switch settings?

Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.

How do I clear the configuration on an HP switch?

Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch. The power and fault lights come on. Continue to press the Clear button while releasing the Reset button. When the Self Test LED begins to blink, release the Clear button.

How do I find the uplink port on a switch?

Step 1 Enter the show running-configuration command to display uplink interface connectivity for the switch.

  1. Switch#sh int te2/1/3.
  2. TenGigabitEthernet2/1/3 is up, line protocol is up (connected)
  3. Hardware is Ten Gigabit Ethernet, address is 381c.1a24.d537 (bia.
  4. 381c.1a24.d537)

How do I configure my Aruba switch?

To configure the AOS switch IP address of the out-of-band management port:

  1. Enable out-of-band management (oobm). AOS-switch(config)# oobm enable.
  2. Assign an IP address to the oobm port. AOS-switch(config)# oobm ip address 10.2.100.68 255.255.255.0.
  3. Add a default gateway to the oobm port.
  4. Save the configuration.