How do I pair my Skullcandy wireless earbuds?

Android. Go to Settings and turn on Bluetooth. In Bluetooth click “Pair new device”. When you see your Skullcandy device come up in the list, tap it and it should be paired with your phone.

How do you turn on Bluetooth on Skullcandy earbuds?

You can activate Bluetooth connectivity on your Skullcandy headphones by holding the Power/Bluetooth button for about 4 to 5 seconds. As soon as you turn on the pairing mode, you’ll see the LED light flash.

How do you turn up the volume on your Skullcandy earbuds?

To turn up the volume, press the right bud twice. To turn down the volume, press the left bud twice. To skip a song forward, press and hold the right bud for 2 seconds. To skip a song backward, press and hold the left bud for 2 seconds.

Why wont my Skullcandy Bluetooth headphones pair?

If your Method Active does not successfully pair to your device, turn the product off. From the off state, hold the power on button for 5 seconds until you see a blue LED and hear “pairing.” Enter your device’s Bluetooth settings and choose Method Active. The product should connect to your device.

How do you turn on Skullcandy headphones?

Press the button on your Tile device and listen for the tune. Hold the Tile close to your device until they connect, it should take about ten seconds. That is all! Your Skullcandy headphones are now activated with Tile!

How do I reset my Skullcandy wireless earbuds?

Once both buds have been powered OFF, touch and hold the button on each bud for 10 seconds to completely reset them (this will power cycle them on and off again). Once both buds have gone through the power cycle, place the buds back in the case until both LEDs show red, and then pull them back out.

How do I know when my Skullcandy earbuds are charged?

BATTERY & CHARGE

  1. To charge your earbuds, place them in the charging case. The earbud LEDs will be solid red while charging.
  2. The LEDs will turn off when fully charged.