How do I Start a remote service in PowerShell?
How do I Start a remote service in PowerShell?
Method 3: Using PowerShell
- Get-Service -ComputerName computername -Name servicename | Restart-Service -Force.
- Get-Service -ComputerName computername -Name servicename | Stop-Service -Force.
- Get-Service -ComputerName computername -Name servicename | Start-Service.
How do I get remote computer services in PowerShell?
Getting Remote Services With Windows PowerShell, you can use the ComputerName parameter of the Get-Service cmdlet to get the services on remote computers. The ComputerName parameter accepts multiple values and wildcard characters, so you can get the services on multiple computers with a single command.
How do I Start the WinRM service on a remote computer using PowerShell?
Enabling PowerShell Remoting
- In a PowerShell console running as administrator enable PowerShell Remoting. Enable-PSRemoting –force.
- Make sure the WinRM service is setup to start automatically.
- Set all remote hosts to trusted.
How would you Start a Windows service on a remote computer?
You can use mmc:
- Start / Run. Type “mmc”.
- File / Add/Remove Snap-in… Click “Add…”
- Find “Services” and click “Add”
- Select “Another computer:” and type the host name / IP address of the remote machine. Click Finish, Close, etc.
How do I start a remote service?
How to: Remotely Start or Stop Service from CMD
- Step 1: Find the service name. If you already know the name of the service skip to step two, if you are unsure of the name of the service start here.
- Step 2: Start or Stop the service. While still in the command prompt type: SC \COMPUTERNAME stop SERVICENAME and press enter.
How can I tell if a service is running on a remote computer?
How to: How to check and kill services running on a remote computer on the same network
- Step 1: To display all services running on a remote computer. From command prompt, type: tasklist /s example c:sers\admin>tasklist /s reception1.
- Step 2: To kill a remote service.
- Step 3: Example.
How do I start WinRM service remotely?
Enabling the WinRM Service
- Open up the GPMC and create a GPO.
- Select Windows Remote Management (WS-Management).
- In the configuration panel check the box for Define this policy setting.
- Select the radio button for Automatic to set the WinRm service to start automatically on boot.
- Click OK to confirm the setting.
How do I start WinRM from command line?
Type winrm quickconfig at a command prompt. If you’re not running under the local computer Administrator account, then you must either select Run as Administrator from the Start menu, or use the Runas command at a command prompt.
How do I enable a service in PowerShell?
Type the following command to enable a service and press Enter: Set-Service -Name “SERVICE-NAME” -Status running -StartupType automatic For example, this command enables the printer spooler service using PowerShell: Set-Service -Name “spooler” -Status running -StartupType automatic Quick note: You may able to use the …