How do you adjust the carburetor on a Yamaha G1?

Yamaha G1 Carburetor Adjustment

  1. Unscrew the air mixture screw.
  2. Turn the screw in until it comes to a slightly seated position.
  3. Turn the screw outwards by 1-1/2 turns.
  4. Push the throttle stop screw backward until the throttle shaft is closed completely.
  5. Turn the screw in by a 1/4 turn.

How do you adjust the carburetor on a golf cart?

Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.

Why does my gas golf cart backfire?

The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.

Why is my golf cart sputtering?

Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.

What causes golf cart hesitation?

In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.

How do I stop my Yamaha golf cart from backfiring?

One simple way to stop the golf cart from backfiring is to use good quality fuel. Once this is done, ensure that the throttle plate is closed by adjusting the accelerator cable at the plate.

How do I increase the speed of my gas golf cart?

Increase the RPM An increase in the input shaft rpm for all differential ratios will produce a higher speed. For a gas golf cart, other than adjusting the governor, the speed may be enhanced by replacing the engine with a higher rpm output model.

Why does my golf cart jerk when I accelerate?

Why does my Club car golf cart jerk when accelerating? The main reason why a Club car golf cart jerks when you accelerate it is due to a misaligned Inductive Throttle Sensor or dirty clutch.

Why does my golf cart not accelerate?

Bad Solenoid If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery’s flow from the battery into the motor. Check out the signs of the bad solenoid.