How do you enlarge a strike plate?

If the misalignment is only ⅛ inch or less, then try to enlarge the hole. After removing the strike plate from the door frame, use a metal file to enlarge the strike plate hole. A half-round file will match the curvature of the latch hole, making it the best choice for widening the strike plate hole.

How are extended strike plates measured?

The easiest way to determine what size strike you’ll need is to measure from the center of the screw holes on the prepared jamb to the edge of the trim and then add ¼”. So, if your trim measures 1-1/2” from the center of where the screw holes are, you should order a 1-3/4” extended strike.

What is an ASA strike plate?

The term “ASA” is still used by some commercial door manufacturers as follows: ASA: The designation for the 4 7/8˝ high strike with lip (per ANSI A115. 2) with the centerline of the strike located @ 40 5/16” above the bottom of the frame.

How do you make a strike plate hole deeper?

This can be corrected by enlarging the bolt pocket or changing the strike plate. To make the bolt pocket deeper, taller or wider, depending on where your bolt is dragging, use a chisel on the bolt hole until it is 1” deep and allows the bolt to fully extend without dragging.

Are strike plates necessary?

Strike Plate This is the plate the latch-tongue, or deadbolt-tongue will connect with. It should sit flush with the door jamb. Any passage or privacy set needs to have a strike plate for the door to latch. Additionally, deadbolts need a strike plate to properly lock.

What is full lip strike plate?

Full Lip Strike: The full lip strike is the most common. As you can see there are 2 different kinds of full lip strikes: round corner or square. The measurement that this strike plate is showing would be considered the width, because it would be the width if it was on the door jamb.

What is a ANSI strike?

A ANSI strike plate reinforces locks and deters tampering or kick-ins. Includes metal and wood screws. Size 4-7/8″ x 1-1/4″ in. Residential, commercial or industrial use. BULK poly bag packaging.