How do you install a DrainEASY bathtub stopper?

Installation:

  1. Simply unscrew your existing bath tub stopper to install the DrainEASY Bath Tub Stopper.
  2. For best results, clean your drains before installation.
  3. Select screw (C) that best fits hole (A) and screw it in base of device (D).
  4. Screw device into the drain opening (B).

How do you use a toe touch tub stopper?

Toe Touch By pushing the toe touch stopper down with your toe, you close the stopper so the rubber seal keeps bathwater from draining. Touch the stopper again and the spring pops the stopper open. The open position empties the water after use.

How do you remove an old bathtub drain stopper?

Remove the Bathtub Drain Stopper

  1. Set the drain to its open position.
  2. Lift up on the drain stopper’s knob and turn it counterclockwise.
  3. After enough turns, the drain stopper should be unscrewed and come free from the drain opening.

Are bathtub stoppers universal?

Not all bathtubs require the same size of drain stopper, they come in different sizes.

Are all drain stoppers the same size?

There is no universal drain hole diameter that applies to every bathroom sink, but 1 1/2 inches is the most common size for a bathroom sink drain opening, according to Signature Hardware. Some bathroom sinks have a slightly narrower opening at 1 1/4 inches, while others are a bit wider at 1 5/8 inches.

How do you clean a toe touch drain stopper?

Toe Touch Bathtub Stopper First push down to open the stopper (like emptying the tub). Then hold the shaft while turning the top counter-clockwise and lift out the stopper. Unscrew the cap and lift the stopper off the strainer. Now you can clean out hair and other debris in the strainer.

Why won’t my tub drain stay open?

Look for an adjustment nut on the end of the U-shaped plate attached to the handle if the weight is still attached to the linkage. Turn this nut clockwise through three or four rotations with a pair of adjustable pliers to shorten the linkage.