How do you pan Glyn Johns?

Panning the Glyn Johns Way Pan your kick and snare mics to the center, as you’d do on any recording. Then, take your overhead mics, and pan the one above the snare halfway to the right. This gives it a little balance without taking it too far to the right.

Why use the Glyn Johns method?

But with the Glyn Johns Method, you can achieve a big, punchy drum sound with just 4 mics! All you need for this technique are 2 overheads, one kick mic, and one snare mic. The majority of the drum sound actually comes from the overheads, while the kick and snare close mics can beef up those two pieces of the kit.

How do you mic a crash cymbal?

The best way to mic a ride cymbal is to use a condenser microphone and locate it in the middle of the edge and the bell of the ride. This special condenser microphone, which is unique for rides, will allow its sound to cut through and separate itself from any mix.

What is Ortf mic placement?

In an ORTF pair, it’s the backside of the microphones that are near touching, rather than the front-side. The capsules are spaced about 17cm, or just over 6.5 inches, apart. The angle is slightly wider than that of XY, at 110 degrees.

Who does Glyn Johns look like?

Others have noted his uncanny resemblance to Liam Gallagher of Oasis; Cillian Murphy, the star of “Peaky Blinders;” and Ronnie (Z-Man) Barzell, the debauched rock impresario in the 1970 camp classic, “Beyond the Valley of the Dolls.” For Mr. Johns, 79, the experience has been amusing — to a point.

What is Glyn Johns known for?

Johns developed a unique approach to the recording of drums, often referred to as the “Glyn Johns Method”. This technique usually employs three microphones: One hoisted several feet overhead to achieve natural perspective of the entire drum kit.

What is XY mic technique?

XY stereo recording uses a coincident pair of directional- or bidirectional, angled microphones. Hence, the directional information is obtained solely from the level difference between signals. In practice, “coincident” means that the microphone capsules must be placed close and normally slightly above each other (fig.

https://www.youtube.com/watch?v=zT774sQDwdc