How far should pipe stick out for tub spout?

According to the installation manual for the spout, the nipple for the spout should be installed a min of 3/8″ to a max of 3/4″ past the finished wall. There is a pipe adapter that you screw onto the nipple. The spout slides over this adaptor and is set in place with a set screw located on the bottom.

How do you fix a pull down diverter?

How to Repair a Shower Diverter

  1. Turn off the water supply to your shower.
  2. Seal off your drain with tape so that small screws or other important parts are not lost down the drainpipe.
  3. Tighten the screws behind the faceplate of the diverter valve.
  4. Disassemble the shower diverter.
  5. Replace the diverter.

How to install a Delta bathtub spout?

Allen wrench

  • Plumber’s tape
  • Cloth
  • Pipe wrench

    • How to remove a Delta tub spout?

    How to Remove a Delta Tub Spout Turn off the water supply to the bathtub. Locate the set screw under the spout near the wall. Insert an Allen wrench into the head of the set screw and turn the screw counterclockwise. Grab the spout close to the tub wall and slide the spout off of the spout stem. Turn off the water supply to the bathtub.

    How to repair a Delta tub?

    1/8 inch Allen wrench

  • Pencil
  • Adjustable pliers
  • Flathead screwdriver
  • Phillips screwdriver
  • White Vinegar
  • Rubber Glove
  • Springs and Seals

    • How to replace a Delta kitchen faucet diverter?

    Reach under the sink to rotate the hot and cold water supply valve clockwise.

  • Place a rag over the cap behind the two-handled faucet spout.
  • Insert a butter knife or a nickel into the slot at the top of the diverter.
  • Wrap the clean diverter threads in one or two layers of thread-seal tape.
  • Replace the faucet cap on the faucet body.