How much does a 4×8 sheet of Hardie panel weigh?

Hardieplank weighs 2.3 lbs per square foot.

How much Hardie siding is on a pallet?

A: There are 280 pieces per pallet for product with ColorPlus® Technology and 308 pieces per pallet for the primed product.

How do you nail Hardie panels?

James Hardie recommends the use of quality, hot-dipped galvanized nails. James Hardie is not responsible for the corrosion resistance of fasteners. Stainless steel fasteners are recommended when installing James Hardie® products near the ocean, large bodies of water, or in very humid climates.

Does Hardie board crack?

Hardie board siding usually cracks due to poor installation. The original installer might have accidentally installed a nail too close to the edge of the siding, causing a crack. You can easily fix it by cleaning it and then using caulk to patch the gap.

How to install hardiepanel vertical siding?

Install HardiePanel stucco finish vertical siding over horizontal and vertical braced wood or steel wall studs spaced a maximum of 24 inches on center. Alternatively, the panels can be installed over wood sheathing covering foam insulation of 1 inch thick or less.

How much does hardieplank siding cost?

James Hardie Board Siding Cost. James Hardie board siding costs $1.50 to $3.50 per square foot on average for the materials only. The average cost to install Hardie siding is $6 and $13 per square foot.Installing Hardiplank shingles on a 1,600 SF house costs $10,000 to $18,000 on average.. James Hardie is the most well-known fiber cement siding brand due to its longevity, appearance, fire

What to know about Hardie board and batten siding installation?

Hardie Board Siding

  • James Hardie Board Batten Siding Colorplus Arctic
  • Hardiplank Board Batten Siding Bing
  • Grey Slate Hardie Shingle Board Batten Siding Creve
  • Board Batten Siding Hardiplank
  • Hardie Siding Board Batten Hardy
  • Hardiplank Board Batten Siding Flickr Sharing
  • Exterior Remodel Pelham Manor
  • Board Batten Austin Pro Siding Windows

    • How to install hardietrim boards on outside corners?

    installing HardieTrim Battens horizontally, they must be installed as a panel joint according to option 2. Option 1 Figure 17 – No horizontal band board – Make a 22.5 – 45 degree weather cut, in the HardieTrim batten, just above the 1/4 in. clearance between panels. Option 2 Figure 18 – Horizontal Band Board – Install a horizontal