How much does it cost to replace a drive shaft on a Ford f150?
How much does it cost to replace a drive shaft on a Ford f150?
The average cost for a Ford F-150 axle shaft replacement is between $143 and $181. Labor costs are estimated between $143 and $181. This range does not include taxes and fees, and does not factor in your specific model year or unique location. Related repairs may also be needed.
How much is a drive shaft for a Ford?
This can cost anywhere from $350-$850 depending on location. Again, the cost of parts is around average for all repairs. with labor topping out the rest of the cost at $150-$250 depending on the service center, state, and taxes for that state.
Is limited slip and posi the same?
TOM: Actually, Jeannie, “posi-traction” is just Chevrolet’s name for limited slip differential on passenger cars. RAY: Normally, on a rear wheel drive car, the power is delivered to both of the rear wheels equally.
Can I drive my f150 without a front drive shaft?
Can you drive a 4WD truck without a front or rear driveshaft? Yes, this is possible, if you drive a traditional 4WD with a lockable center differential. Remove the damaged drive shaft and lock the center differential. This will allow the transfer box to transfer power to the front or rear driveshaft.
What size bed does my 2010 f150 have?
Regular cab models can be had with a 6-foot, 6-inch or 8-foot bed. SuperCab models come exclusively with a 6-foot, 6-inch bed, SuperCrews with a 6-foot, 6-inch or 5-foot, 6-inch bed.
How many miles should U joints last?
In most cases, you have to grease your u-joints every 5,000 miles or so. When you fail to service your u-joints on a regular basis, they will fail. You don’t have to worry about this problem with maintenance free u-joints. Misalignment: This happens when you change the vehicle’s ride height.
What does slip yoke eliminator do?
Slip Yoke and Slip Yoke Eliminator This sliding capability allows for changing length depending on the vehicle’s movements. A slip yoke eliminator, abbreviated SYE, does what the name suggests: It eliminates the slip yoke from the transfer case. Instead, it turns it into a fixed yoke that does not slide.
Why would someone remove a driveshaft?
Re: Question: Why would someone remove the Drive Shaft? If it is a 4wd then it was probably removed because of bad diff, bad U joints, or driveshaft support mount or some other part that was to expensive/difficult to replace.
Is 2010 a good year for Ford F-150?
Yes, the 2010 Ford F-150 is a good truck. We reach our conclusion after considering 549 verified owner reviews giving the truck an overall rating of 4.5/5 with no serious complaints.
How much horsepower does a 2010 5.4 have?
Powertrain/Chassis
POWERTRAIN | 5.4L 3V Triton V-8 |
---|---|
Valvetrain | SOHC, 3 valves per cylinder, Variable Camshaft Timing |
Power | 320 hp @ 5,200 rpm* /310 hp@ 5,000 rpm |
Torque | 390 ft.-lb. @ 3,500 rpm* /365 lb.-ft @3,500 rpm |
Oil capacity | 7 qt |
How long does it take to replace a driveshaft?
In terms of labor, it should not take more than two hours. In most cases, it takes about an hour to replace a drive shaft. This means the total cost will be around $400 to $1500 including labor and parts. You could save a few bucks by replacing the driveshaft yourself as it is not a very difficult process.
How much does a driveshaft cost to replace?
Driveshaft Replacement Cost On average, you can expect to pay anywhere from $400 to $1,260 total but it can easily approach close to $2,000 for some vehicles. If you have a four-wheel drive vehicle, you may have two driveshafts but in most cases, only one will need to be replaced.
What causes slip yoke clunk?
The slip yoke could be the cause of that driveline clunk or bump. Some vehicles with rear-wheel drive and may exhibit a driveline clunk or bump that occurs as the vehicle starts to move forward following a stop. This condition may be caused by the slip yoke not sliding smoothly on the output shaft splines.
What kind of driveshaft does a 2010 Ford F150 have?
Ford F-150 2010, Driveshaft by Cardone Reman®. Cardone Reman Remanufactured Prop Shafts/Driveshafts are engineered to meet or exceed the original fit, form and function. Original designs are scrutinized and improved to make longer…
What is a rear driveshaft spacer for a 2010 Ford F150?
Ford F-150 2010, Rear Driveshaft Spacer by Zone Offroad®. Zone Offroad Products Driveshaft Spacer is designed to allow the use of a stock length driveshaft. This piece is designed to maintain proper tail shaft engagement and reduce the…
What is the Ford F150 throw away drive shaft size?
Repair the “Throw Away” driveshaft that Ford supplied for the F150 Pickup. (Weld to Weld Compressed) – 16.500″. The OEM Ford rear driveshafts have a non-replaceable center support…
How big is the front lift on a 2010 Ford F150?
Ford F-150 with 6″ Rear Lift / with 8.5″ Front Lift 2010, Driveshaft Spacer by Pro Comp®. Driven by genuine off-road enthusiasts, Pro Comp suspension products reflect customer driven, racing influenced, technology and engineering with a…