What is split face concrete block?

Split-Face Block, Split-Faced Block & Rock-Faced Block all mean the same thing: A concrete building unit which appears to have been hand-chiseled (or “split”) to give it a very textured look. In reality, the concrete slurry is poured into a form with the texture already built into it.

How much do split face blocks cost?

Expect to pay about $3 per square foot for split-face concrete or cinder units and add $9 to $12 per square foot for installation labor, supplies, and equipment. A completed, 100-square-foot project will cost between $1,200 and $1,500, depending on the difficulty of the installation.

How often should split face block be sealed?

every 5 to 7 years
Waterproofing Before & After Before: Split face block is extremely porous and needs to be sealed every 5 to 7 years. After: Clearcoat sealants do not leave any residue on the block. Before: Split face block is very porous and susceptible to water penetration.

Do concrete blocks absorb water?

Because concrete blocks are porous, they will absorb large amounts of water if they are located beneath the soil line. Water enters the soil and penetrates the block pores, finally settling on the interior of the block wall.

Can you stain split face block?

A: Brick, block, mortar, natural and manufactured stone, concrete, cast stone, precast, tilt-up precast, and more can be stained to look very natural. Porous masonry that will accept water should work with typical water-based, professional-grade stains.

Do cinder blocks absorb water?

How often should concrete block be sealed?

Building owners in Middleburg, PA should invest in waterproofing for split face concrete blocks every five to seven years. Since split face blocks are very porous, waterproofing is a common preventative maintenance service that minimizes the blocks’ exposure to water damage.

How do you seal cinder blocks?

For the best method for sealing concrete block walls and the best cinder block water barrier, read on.

  1. Apply a Coating Directly On the Bare Wall.
  2. Use a Breathable / Permeable Barrier.
  3. Use a Weather-Resistant Elastomeric Layer.
  4. Use “The Pink Stuff”
  5. Repair Cracks and Fill Voids First.
  6. Install an Air and Moisture Barrier.

The average cost for installing split face block ranges from $10.35 to $12.60 per square foot, according to Homewyse.com. On Angie’s List, one expert said you should be prepared to spend $10 to $20 per square foot, depending on your soil condition and how high you want to build the wall.

What are all these problems with split faced block?

Split faced block is very porous and must be properly flashed and even sealed or water will just travel right through it. The high moisture content of the block allows water to enter the interior of the walls and wet the wall cavity behind the drywall. This causes mold growth and wood rot.

What size is split face block?

– Ideal for foundations and walls – Standard tan color – Strong and versatile – Factory cured to meet or exceed ASTM C-90, certified for strength and absorption – Resembles texture of natural, weathered stone – Color may vary by production run. Please purchase entire projects at one time. – Nominal size concrete

Why does split face block?

Splitface Concrete Blocks. Splitface Concrete Blocks have a deep textured relief which gives depth to the unit while also exposing the inner aggregates. This lends itself to customization through the use of different colored aggregates. Both structural an non-structural Splitface concrete blocks are available.